Can Recasting Your Mortgage Remove PMI? The 80% Rule, Worked Out
Can recasting your mortgage remove PMI? The recast itself cannot. What it can do is land the lump sum that gets your balance under 80% of your home's value, and that is what lets you ask your servicer to cancel PMI. The distinction matters because the cancellation is a separate request, and servicers do not volunteer it.
The end state, then the rewind
Picture where this lands. You bought a $400,000 home with 5% down, so the loan is $380,000 and PMI has been riding on the statement every month. Then you sell your old place, net $100,000, and put it against the mortgage. The balance drops to $280,000. You recast. The payment is re-amortized on $280,000 at your same rate, and the PMI line disappears.
Two separate requests got you there, and that is the whole trick. The paydown plus recast lowered the payment. The PMI cancellation request, made in writing after the balance crossed 80%, removed the insurance. People who only do the first one keep paying PMI on a loan that no longer needs it.
Can recasting your mortgage remove PMI? What the recast does and does not do
A recast applies your lump sum to principal and re-amortizes the loan over the remaining term. Rate unchanged, term unchanged, lower required payment. That is all it touches. PMI is a separate provision of the loan, and a recast changes nothing about it on its own.
What removes PMI is the loan-to-value ratio. For borrower-initiated cancellation on a conventional loan, the line is 80% of the original property value for a one-unit primary residence or second home. Cross it and you may request cancellation. Stay above it and PMI stays, recast or no recast.
The two connect through your lump sum, not through the recast. A $60,000 paydown on that $400,000 purchase takes the $380,000 balance to $320,000, exactly 80%. That paydown is what earns the cancellation. The recast is what turns the paydown into a lower monthly payment. Run both sides of it on our mortgage recast calculator before you move the money, so you know the new payment before you commit the lump sum.
The 80% line, with its conditions
Hitting 80% is necessary but not sufficient. The servicer will also check your payment history: the loan must be current, with no payment 30 or more days past due in the last 12 months and none 60 or more days past due in the last 24. And the servicer must verify the property value has not fallen below the original value, often through an automated valuation.
That last condition is the quiet dealbreaker. If your market dipped and the home appraises under $400,000 now, the servicer can deny cancellation even though your balance math is right. In that case you may need a full appraisal at your own expense, or you wait for values to recover. For investment properties and 2-to-4-unit homes, the line is stricter at 70%.
Decision rules for the lump sum
If your lump sum takes you to 80% or below, do all three in sequence: pay down, request PMI cancellation in writing, then recast. One phone call can start it, but get the cancellation procedure in writing before the money moves.
If the lump sum gets you close but not there, say 82 to 85% LTV, the recast still lowers your payment and normal amortization plus appreciation closes the last gap. Set a calendar reminder to request cancellation when you cross 80% rather than trusting yourself to remember in two years.
If the lump sum leaves you above 90%, pause the recast question entirely and ask the harder one: does this money earn more against a PMI-bearing principal balance, or somewhere else? A recast that leaves PMI in place is just a payment reduction. Sometimes that is exactly what you need. Sometimes the money belongs in an emergency fund instead. The recast versus refinance comparison helps when the rate environment, not just the balance, is part of the question.
One more check before anything moves: confirm your servicer actually offers recasts, and ask for the minimum lump sum. Minimums vary by servicer, and the minimums run higher than most people expect. Get both answers, the recast terms and the PMI cancellation procedure, in the same call.
Frequently Asked Questions
Can recasting your mortgage remove PMI by itself?
No. A recast re-amortizes your loan on a lower balance at the same rate and term, which lowers the payment. PMI cancellation is a separate request you make to your servicer once your loan-to-value reaches 80% of the original property value.
How much principal do I need to pay down to cancel PMI?
Enough to bring the balance to 80% of the original home value. On a $400,000 home bought with 5% down ($380,000 loan), you need the balance at or below $320,000, which means a $60,000 paydown. The paydown that funds a recast often gets you there in one move.
Does the servicer cancel PMI automatically after a recast?
No. Automatic PMI termination happens at 78% LTV on the original amortization schedule, which a recast does not change. Borrower-initiated cancellation at 80% requires a written request. Servicers do not volunteer it, so ask in writing and keep proof.
Will I need a new appraisal to cancel PMI after a recast?
The servicer must verify the property value is not below the original value, often with an automated valuation. If your home lost value since purchase, cancellation can be denied even at 80% of the original price. A full appraisal is sometimes required at your expense.
Can I recast and remove mortgage insurance on an FHA loan?
Usually not in one move. Most servicers do not offer recasts on FHA or VA loans, and FHA mortgage insurance has its own removal rules that differ from conventional PMI. Check our guide to recasting FHA and VA mortgages before planning around it.
Model the Recast Before You Move the Money
Enter your balance, lump sum, and rate to see the new payment, and check whether the paydown crosses the 80% PMI line.
Calculate My Recast